Note! The descriptions and instructions below are for use with the YOYOPower SMS 2.0 mobile app.
For settings and usage with SMS commands, see section SMS COMMAND LIST (PDF for download)
A) Power lost and restored
- YOYOPower will notify Master and Users by SMS if the mains power is lost and when it’s restored.
- The SMS notification can be omitted by settings (DEVICE SETTINGS > NOTIFICATIONS).
B) What is power load alarm (W)?
Only applicable on EMP and EOP models.
With the power load alarm activated the Master and User will be notified if the power load (W) exceeeds or fall below set values.
The maximum power load on YOYOPower is 3500 W.
The power load range that can be set is 0 — 3500 W.
C) How to set the power load alarm?
- At the Start page, select the unit to set the alarm for, press the > at the right hand side.
- Go to Power monitoring > Power load (W).
- Set the upper value (W).
- Set the lower value (W).
- Save settings and activate function by pressing OK.
- To activate/deactivate the Power load alarm function, tap the [green] or [red] button.
D) What is power consumption (kWh)?
Only applicable on EMP and EOP models.
- YOYOPower can measure and report accumulated power consumtion (kWh) during a period.
- YOYOPower can also check the actual power consumption (W).
- The pre-defined periods are ’Today’ (since midnight 00:00 hrs until time of check), ’This week’ (since Monday 00:00 until time of check), ’This month’ (since the 1st day in the month until time of check).
- A report is automatically sent after the end of the selected period above. The automatic reporting can also be omitted.
D) How to set power consumption (kWh) and reporting?
Power consumption (kWh):
- At the Start page, select the unit to set the reporting for, press the > at the right hand side.
- Go to Power monitoring > Power consumption (W).
- Select period (Today, This week or This month) to measure (check).
- Save settings and activate function by pressing OK.
- Select periodicity of the report to receive by SMS.
- Save settings and activate function by pressing OK.
- To activate/deactivate the Power load alarm function, tap the [green] or [red] button.
Check the actual power consumption:
- Tap the button OK
Select report periodicity:
- Tap the the desired period (Day, Week or Month).
- Automatic reporting can also be omitted by tapping the button None.